Firmware update

[duchenef]

Has anyone managed to shift from calibration mode to normal mode? For me, right after
$ cd /path/to/Sensly_Install/
$ sudo ./Update.sh
I get the following message/
Can't init. Ensure that Boot0 is enabled and reset device
I'm using a rpi3 from what looked like a ready to use image I found on altitude tech's website...

[ferazambuja]

Same from me here. Pluging the USB from the board and running dfu-util I get:

dfu-util 0.9

Copyright 2005-2009 Weston Schmidt, Harald Welte and OpenMoko Inc.
Copyright 2010-2016 Tormod Volden and Stefan Schmidt
This program is Free Software and has ABSOLUTELY NO WARRANTY
Please report bugs to http://sourceforge.net/p/dfu-util/tickets/

Found DFU: [0483:df11] ver=2200, devnum=6, cfg=1, intf=0, path="1-1.1.3", alt=1, name="@Option Bytes  /0x1FFFF800/01*016 e", serial="FFFFFFFEFFFF"
Found DFU: [0483:df11] ver=2200, devnum=6, cfg=1, intf=0, path="1-1.1.3", alt=0, name="@Internal Flash  /0x08000000/064*0002Kg", serial="FFFFFFFEFFFF"

[duchenef]

It is actually unclear why a firmware update should even be necessary after calibration is done. As far a I can seen, there's a calibration script that pulls out raw data. The main script use calibration formulas to adjust raw data. What does the "other" firmware do? No idea. Anyhow, would the update work, what if you want to calibrate again? Would you have to roll back to the "calibration" firmware?