[BUG] load/unload from screen does not operate properly #325
Description
Did you test the latest extui code or prerelease?
Yes, and the problem still exists.
Bug Description
If I download and compile the latest firmware from the github, if I select load, the printer heats to 200°, moves the gantry up and then right back down without moving the extruder. If I select unload, it heats to 200°, moves the gantry up, unloads the filament maybe 10mm, then immediately feeds 10+mm as it starts extruding and then the extruder skips as it is extruding too fast (it's only brief, so maybe 15-20mm) stops and lowers the gantry back down. If I download and compile the 6.1 tagged source and install that, load/unload works properly. This happens on both the SE and Max.
Bug Timeline
No response
Expected behavior
No response
Actual behavior
No response
Steps to Reproduce
No response
Version of CR6Community Firmware
6.2
Printer model
Creality CR-6 MAX
Motherboard
Creality v4.5.3
Display
Creality CR-6 stock touch screen
Mods
No response
Add-ons
No response
Bed Leveling
No response
Your Slicer
No response
Host Software
No response