V21 code not using feedback?

[tomdertech]

Looking at the Arduino code for the V21, it seems that the feedback is not used?

It only seems to be read in the code and send as a tone to the speaker?

FEEDBACK_value=analogRead(FEEDBACK_pin);
if(sound_flag) tone(SPK_pin,FEEDBACK_value*2,50);

In your videos you show it working, how is it used?

[GaudiLabs]

Hi Tom The feedback drive is still in beta, you find the code in Dropper Beta Library on gitHub. What is the proiect or application you are working on? Are you working independently or for an institution? Best, Urs

…

On June 11, 2017 9:32:55 PM GMT+02:00, Tom Myers ***@***.***> wrote: Looking at the Arduino code for the V21, it seems that the `feedback` is not used? It only seems to be read in the code and send as a tone to the speaker? `FEEDBACK_value=analogRead(FEEDBACK_pin);` `if(sound_flag) tone(SPK_pin,FEEDBACK_value*2,50);` In your videos you show it working, how is it used? -- You are receiving this because you are subscribed to this thread. Reply to this email directly or view it on GitHub: #4

----------- GaudiLabs --------------------------------------------- Urs Gaudenz | Neustadtstrasse 7 | 6003 Luzern urs@gaudi.ch | +41 (0)76 480 1772 http://www.gaudi.ch ---------------------------------------------------------------------------

[tomdertech]

OK. I have seen it. Are there any supporting docs?

I have no application in mind, just a curious independent researcher

[kevinyu1101]

looks like FEEDBACK pin check the voltage of REF_GND on the top siade of carrier PCB frame, why?