How to connect?

[lin-ycv]

Hello,

I have KukavarProxy installed on my KRC4 8.3 controller, and I'm connected to the controller thru KLI.
On my laptop (IP is configured 172.31.1.150 /16) I open OpenShowVar, but in the add variable, Robot list (Serial @ IP Address) is empty, and I cannot type into that field.

Is there some special setup required? or am I connected to the wrong port?

[davidrobot]

font{ line-height: 1.6; } ul,ol{ padding-left: 20px; list-style-position: inside; } you must set up the UDP port 6999 in the KLI NAT configuration. liangtaocn ***@***.*** 签名由 网易邮箱大师 定制 On 3/16/2021 12:00，Victor ***@***.***> wrote： Hello, I have KukavarProxy installed on my KRC4 8.3 controller, and I'm connected to the controller thru KLI. On my laptop (IP is configured 172.31.1.150 /16) I open OpenShowVar, but in the add variable, Robot list (Serial @ IP Address) is empty, and I cannot type into that field. Is there some special setup required? or am I connected to the wrong port? —You are receiving this because you are subscribed to this thread.Reply to this email directly, view it on GitHub, or unsubscribe.

[lin-ycv]

I added port 6999 UDP on the controller's NAT, did a reboot, but my robot list is still empty

[dddomodossola]

Are you able to ping the robot?

[lin-ycv]

yes i can ping the robot no problem
kukavarproxy is running (also tried crosscom), port 6999 and 7000 TCP/UDP is configured

[davidrobot]

font{ line-height: 1.6; } ul,ol{ padding-left: 20px; list-style-position: inside; } try ping your PC from robot , may be the firewall of you PC

[lin-ycv]

no the controller cannot ping anything, even after turning off my firewall, both pc and controller (controller was off by default?)

is the controller suppose to be able to ping anything? I've never been able to ping anything with the controller before

[lin-ycv]

I forgot to mention, even tho my controller is unable to ping my PC, if I manually send TCP messages to KukavarProxy thru to 172.31.1.147:7000, I do get a reply