After the dcp indicator is enabled, dcgm-exporter reports an error

[15234660879]

DCGM Version:3.3.0
DCGM-exporter Version: 3.3.0-3.2.0
GPU: A100

When the following DCP indicators are enabled, an error is reported. If the DCP indicators are not enabled, they can run normally.Specific Error message "Failed to watch metrics: Error watching fields: Bad parameter passed to function"

DCP metrics

DCGM_FI_PROF_GR_ENGINE_ACTIVE, gauge, Ratio of time the graphics engine is active (in %).
DCGM_FI_PROF_SM_ACTIVE, gauge, The ratio of cycles an SM has at least 1 warp assigned (in %).
DCGM_FI_PROF_SM_OCCUPANCY, gauge, The ratio of number of warps resident on an SM (in %).
DCGM_FI_PROF_PIPE_TENSOR_ACTIVE, gauge, Ratio of cycles the tensor (HMMA) pipe is active (in %).
DCGM_FI_PROF_DRAM_ACTIVE, gauge, Ratio of cycles the device memory interface is active sending or receiving data (in %).
DCGM_FI_PROF_PIPE_FP64_ACTIVE, gauge, Ratio of cycles the fp64 pipes are active (in %).
DCGM_FI_PROF_PIPE_FP32_ACTIVE, gauge, Ratio of cycles the fp32 pipes are active (in %).
DCGM_FI_PROF_PIPE_FP16_ACTIVE, gauge, Ratio of cycles the fp16 pipes are active (in %).
DCGM_FI_PROF_PCIE_TX_BYTES, gauge, The rate of data transmitted over the PCIe bus - including both protocol headers and data payloads - in bytes per second.
DCGM_FI_PROF_PCIE_RX_BYTES, gauge, The rate of data received over the PCIe bus - including both protocol headers and data payloads - in bytes per second.