In the original adxl.cfg, the adxl is configured as an MCU, which brakes the printer down on restart. Needs to be modified to the following for it to work:
[adxl345]
cs_pin:mcu1:gpio13
spi_software_sclk_pin:mcu1:gpio14
spi_software_mosi_pin:mcu1:gpio15
spi_software_miso_pin:mcu1:gpio12
[resonance_tester]
accel_chip: adxl345
min_freq: 5
max_freq: 90
accel_per_hz: 150
hz_per_sec: 2
probe_points:
probe_points:
400, 400, 50
When changing the adxl.cfg, the passage in printer.cfg which defines the adxl can be removed.
In the original adxl.cfg, the adxl is configured as an MCU, which brakes the printer down on restart. Needs to be modified to the following for it to work:
When changing the
adxl.cfg, the passage inprinter.cfgwhich defines the adxl can be removed.