Configure autopilot through osd

[brat002]

Does this osd allow to configure flight controller via rc sticks?
It is what many people need for ardupilot.

[trgFPV]

No currently it is not possible to configure ardupilot via the sticks with this osd. I heard minimosd-ng can do it.

[mkschreder]

I can implement it. But sounds like it is going to need support from the autopilot.

[trgFPV]

The biggest (and only) issue we see is that you can not stop the autopilot from moving the control surfaces while navigating the menu.
One solution could be using the RC*_DZ command to set the deadzone very high while the osd is in configuration mode.

[brat002]

Look on PItlab OSD, where navigation through settings implemented via 3 pos
rc switch

2016-10-04 20:53 GMT+03:00 trgFPV notifications@github.com:

The biggest (and only) issue we see is that you can not stop the autopilot
from moving the control surfaces while navigating the menu.
One solution could be using the RC*_DZ command to set the deadzone very
high while the osd is in configuration mode.

—
You are receiving this because you authored the thread.
Reply to this email directly, view it on GitHub
#35 (comment),
or mute the thread
https://github.com/notifications/unsubscribe-auth/ADyecKMEnaGMKoCJCfSUlR4Jzknb-Ub5ks5qwpK2gaJpZM4KEqlx
.

[mkschreder]

OSD should not be on when in the settings mode. However the whole osd
software needs a rewrite because current design does not easily allow such
flexibility.

On Tue, Oct 4, 2016 at 8:52 PM, brat002 notifications@github.com wrote:

Look on PItlab OSD, where navigation through settings implemented via 3 pos
rc switch

2016-10-04 20:53 GMT+03:00 trgFPV notifications@github.com:

The biggest (and only) issue we see is that you can not stop the
autopilot
from moving the control surfaces while navigating the menu.
One solution could be using the RC*_DZ command to set the deadzone very
high while the osd is in configuration mode.

—
You are receiving this because you authored the thread.
Reply to this email directly, view it on GitHub
<#35 (comment)
,
or mute the thread
<https://github.com/notifications/unsubscribe-auth/
ADyecKMEnaGMKoCJCfSUlR4Jzknb-Ub5ks5qwpK2gaJpZM4KEqlx>

.

—
You are receiving this because you commented.
Reply to this email directly, view it on GitHub
#35 (comment),
or mute the thread
https://github.com/notifications/unsubscribe-auth/AERqiRfX_imlJrAOauqHhz813dRyIqXSks5qwqBtgaJpZM4KEqlx
.