diff --git a/07.LED_TOUCH_CONTROL/led_touch_control.py b/07.LED_TOUCH_CONTROL/led_touch_control.py
new file mode 100644
index 0000000..1b5f80b
--- /dev/null
+++ b/07.LED_TOUCH_CONTROL/led_touch_control.py
@@ -0,0 +1,21 @@
+# Code to control LED by capacitive touch on the ESP32 board.
+
+import machine
+from machine import TouchPad,Pin
+
+# The 4 pin LED pins are connected to GPIO pins numbered 15,4 and 2 in the following way:
+red = machine.Pin(15, machine.Pin.OUT)		
+blue = machine.Pin(4, machine.Pin.OUT)
+green = machine.Pin(2, machine.Pin.OUT)
+
+on_pad = TouchPad(Pin(14))		# This will signal the touch for turning the LED on.
+off_pad = TouchPad(Pin(12))		# This will signal the touch for turning the LED off.
+
+while True:
+	x = on_pad.read()			# Read the sensor values and wait for a touch.
+	y = off_pad.read()
+	if (x<100):					# When the ON sensor is touched, turn on the LED.
+		green.on()				# We are using the Green colored LED as an example, any of the LED colors may be used.
+	if (y<100):					# When the OFF sensor is touched, turn off the LED.
+		green.off()	
+
diff --git a/07.LED_TOUCH_CONTROL/readme.md b/07.LED_TOUCH_CONTROL/readme.md
new file mode 100644
index 0000000..f1d77e7
--- /dev/null
+++ b/07.LED_TOUCH_CONTROL/readme.md
@@ -0,0 +1,15 @@
+# 07.ACCESS_POINT
+## NOTE:
+This program will run only on the *ESP32* board, as it is using the capacitive touch functionality.
+
+To run the program use the following ampy command
+
+## MAC OS
+```bash
+    ampy --port /dev/tty.SLAB_USBtoUART run led_touch_control.py
+```
+
+## Linux
+```bash
+    ampy --port /dev/ttyUSB0 run led_touch_control.py
+```