Printer settings

[Lucas183]

Hey Seedsigner,

Could you please share your printer settings?
What was your nozzle size you used?

Kr
Lucas

[SeedSigner]

I should add some suggestions to the ReadMe as best-practices emerge for printing these.

I am using a 0.15mm nozzle, and printing at the lower end of the temp range for the PLA I am using (I'm using Hatchbox and run the first layer at 200 and the rest at 195). I clean the print surface with 99% isopropyl alcohol between prints, and use a little bit of AquaNet hair spray to improve adhesion. Bed temp is at 60. I also slow the first layer down to 10 mm/s and run the rest at default Prusa "Quality" (not "Speed") settings. I also use the PrusaSlicer's variable layer height feature to minimize the number of middle layers, but make sure that there are 3 layers for the lettering on both the top and the bottom. Feel free to ask about any other settings if I've missed anything.