Working on cutting 3/16" acrylic sheet. When I cut a full circle, I need the cut to go a little further to "close the gap" or overlap the start/end point.
Example: Cut circle with a circumference of 100mm. I need the cut to go 100.05mm in circumference to overlap the start/end points.
The exporter is working 100% fine. I want to know if this option can be added.
I am running Smoothieware on a MKS Sbase board. Cutting through Pronterface on Ethernet.
Attached is a 10X photo on the start/end point.
Thank you!
Working on cutting 3/16" acrylic sheet. When I cut a full circle, I need the cut to go a little further to "close the gap" or overlap the start/end point.
Example: Cut circle with a circumference of 100mm. I need the cut to go 100.05mm in circumference to overlap the start/end points.
The exporter is working 100% fine. I want to know if this option can be added.
I am running Smoothieware on a MKS Sbase board. Cutting through Pronterface on Ethernet.
Attached is a 10X photo on the start/end point.
Thank you!