ZBT-8102-AX-M2-T - Problem 5G module - Sim Orange #4021
Answered
by
Ysurac
wouam31200
asked this question in
Q&A
-
|
Hi, I have a router with one module. I have a SIM card: In the wizard, I set the APN, but the connection isn't working. I edited the network file to add the user and password. Even after adding the user and pass, it doesn't work. I don't see where I could have gone wrong! I tried the firmware rooter, and it worked the first time. Thanks everyone! |
Beta Was this translation helpful? Give feedback.
Answered by
Ysurac
Aug 5, 2025
Replies: 3 comments 10 replies
-
|
Hi everyone, I've been trying things out...but it's not registering.
I tried to add If anyone has any ideas...thanks |
Beta Was this translation helpful? Give feedback.
6 replies
-
|
Hi, I still have a connection in: idle |
Beta Was this translation helpful? Give feedback.
-
|
Yes, sorry: |
Beta Was this translation helpful? Give feedback.
-
|
Beta Was this translation helpful? Give feedback.
-
|
You removed username and password ? You can set APN as "orange" but shouldn't be needed. |
Beta Was this translation helpful? Give feedback.
-
|
Hi, I just ran the test without an APN, still the same... |
Beta Was this translation helpful? Give feedback.
-
|
Hi, With both SIM cards, it sees the carrier but doesn't connect. In the logs, I still get the same two errors: I tried with RooterFirmware. And I noticed:
Do you think it would be possible to manage the ECM connection using OpenMPTCP? Thank you. |
Beta Was this translation helpful? Give feedback.
0 replies
-
|
Hi, I installed the OpenMPTCP firmware, did a reset, and checked the 5G module, without entering any information. And still no connection. |
Beta Was this translation helpful? Give feedback.
4 replies
-
|
ECM is like a normal ethernet, you can follow the Luci part of: https://openwrt.org/docs/guide-user/network/wan/wwan/ethernetoverusb_cdc |
Beta Was this translation helpful? Give feedback.
Answer selected by
wouam31200
-
|
Hi, Small oddity:
I tested it with a Quectel EM12-G module, and it works the first time with ModemManager. Just the gateway problem. Quick question: Thank you for taking the time to answer me. |
Beta Was this translation helpful? Give feedback.
-
|
Where in the documentation ? This must be unchecked. |
Beta Was this translation helpful? Give feedback.
-
|
Hello! I'm not an English pro...but I think I understood that it had to be ticked. After trying since Saturday...I have the impression that the ECM is malfunctioning...
Create a DHCP connection on eth2...et voilà! Hence my little question! PS: I'm not here to minimize your work, I can take up a lot of my time trying to move your project forward when situations are unusual. |
Beta Was this translation helpful? Give feedback.
Sign up for free
to join this conversation on GitHub.
Already have an account?
Sign in to comment
ECM is like a normal ethernet, you can follow the Luci part of: https://openwrt.org/docs/guide-user/network/wan/wwan/ethernetoverusb_cdc
So set usb* as WANs interfaces in DHCP and this should work.