About eval.py？

[hoshizhang]

Thank you for your excellent work, how should I run the test when I have finished the second stage of training? What files do I need to get to run the eval.py code? What is the inp_map for the test set and the required smpl parameters? My current practice is to use the network model trained in the first stage to predict the inp_map of the test set. Can I do this? Can you tell me the exact procedure? Thank you very much!

[hoshizhang]

Thank you for your excellent work, when I finish the second phase of training, how should I test? What files are needed to run the eval.py code? What are the inp_map and required smpl parameters for the test set? I now have a general understanding that the inp_map obtained in gen_pose_map_out_smpl.py will affect the accuracy of the test. Can you tell me the specific steps? Thank you very much!

Here, using the smpl_parms.pth in the test set, the result is such that it can be observed that the color block is discontinuous, resulting in bad test results.

When I changed the file name referred to by the above arrow to smpl_parms_pred.pth, the following result occurred. It can be observed that the figure is clear, but it does not match the gt diagram, resulting in bad indicators.

I would appreciate it if you could get back to me and inform me of the correct course of action!

[R33333]

Thank you for your excellent work, when I finish the second phase of training, how should I test? What files are needed to run the eval.py code? What are the inp_map and required smpl parameters for the test set? I now have a general understanding that the inp_map obtained in gen_pose_map_out_smpl.py will affect the accuracy of the test. Can you tell me the specific steps? Thank you very much!

Here, using the smpl_parms.pth in the test set, the result is such that it can be observed that the color block is discontinuous, resulting in bad test results.

When I changed the file name referred to by the above arrow to smpl_parms_pred.pth, the following result occurred. It can be observed that the figure is clear, but it does not match the gt diagram, resulting in bad indicators.

I would appreciate it if you could get back to me and inform me of the correct course of action!

I'm wondering if you have solved this problem. I'm also facing this problem. Do you have any good suggestions?