How to connect the trackpoint board to the keyboard PCB? #7
Description
Hi,
I'm in the middle of planning an "embedded" trackpoint controller board support to my variation of the corne.
I've added the driver board electronics as SMT components similarly to the buzzard and would like to connect the controller board to the PCB to the right of the thumb cluster (increase the right side PCB just a little bit). This way I won't have to play around with too much rewiring (I think).
However, I'm unsure how to actually connect the controller board to the keyboard PCB. I thought of soldering right angle pins over the pads between the controller board and sensor module, this way I could at least socket the controller board. I'm just afraid it would be too flimsy and hard to solder.
Do you have any suggestions?
Thanks