No support for IPV6 tunnel endpoints

[ernstjo]

There is no IPv6 support for tunnel end points. It occurs an error "invalid ip address" if you use IPv6 addresses for local and remote ip address. Thus, not compatible with Mikrotik IPv6 EOIP. Please extend support.

[bbonev]

True, IPv6 is not implemented at all. I am currently working on DKMS maybe IPv6 comes afterwards?

In case you can contribute protocol specification or code, you are welcome.

[zoigecyb]

Maybe it's not a very good solution, but i tried ROS v7 on older hardware and it causes drastically high cpu load...
In my case I use IPv6 over IPv4 and all works fine.
I'm using +- old RB750Gr3 on v6.49 with 1Gb EOIP tunnel over internet and recieve 800-870Mbps with IPv4 and ~890-900 with IPv6 over IPv4 (seems it works better?)

[b00tkitism]

+1 for ipv6 support 😍