Rotate "cutouts" parameter in lasercutoutSquare module

[Vincent14]

Hi,

I'm afraid to not be able to finish my project due to a small issue: I would create a cutout and rotate to 45°, is it possible?

[bmsleight]

Sorry - Not sure I understand - rotate([0,0,45]) ?

[Vincent14]

Not on the lasercutoutSquare, only on the cutout, like this: http://2.bp.blogspot.com/-n4eNspGX25k/TpEkxjXe8DI/AAAAAAAACoo/wHiH_pEI-3w/s1600/fl%25C3%25A8ches+inkscape+6.png

Where dotted lines are the square and diamond is the cutout

[yawor]

I would like to see this too. This would allow to, for example, put an internal wall inside a box at some angle, not just perpendicular to the floor. For example a card holder where cards are kept at some angle.

[bmsleight]

Understood will try and have a go at this, soon (March 2020).
Pull requests also accepted :)