[Failure] Gigabyte GA-H110M-H Rev 1.0

[Derpitron]

Motherboard model: Gigabyte GA-H110M-H Rev 1.0
BIOS Chip: Macronix mz25l6473fm2i-08g
BIOS ver: OEM F28a (https://www.gigabyte.com/Motherboard/GA-H110M-H-rev-10-11-12/support#support-dl)
Intel ME ver: 11.8.94.4494 (generation 3)
CPU: Intel i3 7100

Boot guard, secure boot, disabled. I used a Ch341a programmer to flash the bios chip.

Removal modes tested:

1. -S (code removal + set HAP bit): Black screen (no signal) on boot. Spools the system fans, they seem to change speed, but there is no display output (No Signal). After leaving it for a few minutes, it doesn't change from this state.
2. -s (set HAP bit): Boots up to the Vendor Logo, then immediately restarts the PC+fans. Bootloop.
3. default mode (code removal): Same as -S mode above, i.e No Signal and refuses to boot up.

[Derpitron]

https://winraid.level1techs.com/t/used-spi-programmer-on-gigabyte-b250m-now-reboot-loop/33037/12

This method might work, but using UEFITool I wasn't able to find the required code section