There is no way to change the flow in Fluidd while printing.

[Megastrong1]

I encountered the fact that it seems the diameter of the plastic was slightly smaller than I used before. And when trying to adjust the flow in Fluidd, I could not do it. More precisely, the value is set, but then again becomes 100%. What could be the problem?

[frap129]

What slicer are you using? Sounds like the flow is getting reset

[Megastrong1]

I'm using prusa slicer 2.9.2. But the settings are not much different from those printers that I configure in it. I repair printers in my city and I constantly have to configure profiles for different printers. But this problem only occurs on open q1. Do you have such problems?