scan completed check again

[sergeystoyan]

Hi guys!
The stick is connected, the XA is configured, and it's connected to Protherm. However, the data isn't showing up in the EBUS bus. Can anyone tell me how to fix this?

s6-rc: info: service legacy-services successfully started
[13:26:28] INFO: eBUSd addon version 26.1.6
[13:26:30] INFO: ebusd --foreground --updatecheck=off --mqtthost=core-mosquitto --mqttport=1883 --mqttuser= --mqttpass= --mqttjson --mqttint=/config/mqtt-hassio.cfg --device=ens:10.1.1.141:9999 --mqttjson --configpath=https://ebus.github.io/ --scanconfig
2026-03-22 13:26:30.427 [device notice] transport opened
2026-03-22 13:26:30.431 [main notice] ebusd 26.1.26.1 started with broadcast scan on device: 10.1.1.141:9999, TCP, enhanced
2026-03-22 13:26:31.157 [bus notice] bus started with own address 31/36
2026-03-22 13:26:31.157 [device notice] reset, supports info
2026-03-22 13:26:31.158 [bus notice] signal acquired
2026-03-22 13:26:31.164 [device notice] extra info: firmware 1.1[5b02].1[5b02], jumpers 0x0b
2026-03-22 13:26:31.808 [mqtt notice] connection established
2026-03-22 13:26:41.159 [main notice] starting initial broadcast scan
2026-03-22 13:26:41.290 [update notice] sent write Broadcast Queryexistence QQ=31:
2026-03-22 13:27:51.292 [main notice] scan completed 1 time(s), check again
2026-03-22 13:29:01.294 [main notice] scan completed 2 time(s), check again
2026-03-22 13:30:11.296 [main notice] scan completed 3 time(s), check again
2026-03-22 13:31:21.299 [main notice] scan completed 4 time(s), check again
2026-03-22 13:32:31.301 [main notice] scan completed 5 time(s), check again
2026-03-22 13:33:41.304 [main notice] scan completed 6 time(s), end