Waveshare USB-CAN-A Challenges #45
Description
Hi,
First I would like to thank you for all your efforts for the community.
I have a Waveshare USB-Can-A that I have attached to a Xantrex XC Pro supporting RV-C. I have the latest version of VanCanSetup, as well as Helper, Gui. I have attempted to install via the command line. I do not see the Can10 in the Gui. Info from the inverter/charger does not show up in the GUI. Looking for any advice and suggestions. Below are the steps I did, plus some info asked for, that I saw in earlier posts.
Thanks Scott.
Available actions:
Install and activate (i)
Reinstall (r) based on options provided at last install
Uninstall (u) and restores all files to stock
Quit (q) without further action
Display log (l) outputs the last 100 lines of the log
Choose an action from the list above: i
CANbus interface definitions:
interface: ( can10 ) custom GS USB
Xantrex XC Pro (can10) 1a86:7523
Choose a device type for can10 from the list above (by number) (cr for no change): 3
creating custom device
usb 1-1.1: New USB device found, idVendor=1a86, idProduct=7523, bcdDevice= 2.64
usb 1-1.1: Product: USB Serial
select this device for can10 (y/n)?: y
enter optional name for can10 (cr for none): Xantrex XC Pro
enter serial number manually (cr for none):
can10 configuration updated
CANbus interface definitions:
interface: ( can10 ) custom GS USB
Xantrex XC Pro (can10) 1a86:7523
Available actions:
Add a USB interface (a )
Delete existing interface (d )
blank line if done with changes
interface may optionally be added to the action, (e.g. a hat or d 11)
USB interface must be 10 or greater
Hat interface should be entered as 'h' or 'hat'
Choose action from list above:
installing CANbus ports
removing scripts from old version of VeCanSetup
adding udev rules for can10
updating VeCanSetup udev rules
installing spi1-1cs overlay
new interfaces will not become active until after a reboot
Reboot system now (y) or do it manually later (n): y
rebooting ...