Several questions regarding GoHeishaMon

[eldrik]

Hi,
today I tried GoHeishaMon on a raspberry, so far it worked without a problem connected to CN-NMODE thumbsup.

By know I am using Heishamon via esp8266 as my primary data source which is connected to CN-CNT via my tests some things came into my mind.

• Is there any kind of webservice for the GoHeishaMon available when running on a raspberry?
• Is the s0 Meter & 1Wire feature available like it is on the actual Heishamon project?
• Should both versions run fine in parallel when one is set to readonly mode? On my test it was not possible without data loss and messages like "Received wrong header!", maybe there are more config options that I have missed?

Kind regards
Eldrik

[eldrik]

adding a note to the point running Heishamon and GoHeishaMon in parallel & available Set Commands.

If setting HeishaMon to read only and GoHeishamon to read/write does not produce any errors on GoHeishaMon side, even HeishaMon is still reading the data fine, so there must be some code difference on GoHeishaMon side that differs.

Would be nice if even GoHeishaMon keeps working after a role switch (HeishaMon read/write and GoHeishaMon read only) to get a failover scenario (ethernet broken, wifi as backup etc.)

Further it seems that the Set Command for setting the water pump speed is not available, any chance that will be ported from HeishaMon Project like other new Topics that are available within version 3.2??

panasonic_heat_pump/commands/SetMaxPumpDuty