Another 3D-Printed Holder for M18 connector

[TheRepairforge]

While preparing to post this, I realized others have done their supports already...

I think I will share anyway, as this one is a bit different :
it is a 3D-printed holder for the inexpensive M18 battery connector you can find on AliExpress.
It allows you to easily slide the connector in, click the battery on and off smoothly, and secure the connector with glue or 2.6×12 mm plastic screws.

This first version also provides space at the back for a small circuit test plate, where you can solder or plug an FTDI reader.
If a PCB design becomes available, I plan to adapt the holder to fit it and eventually create a fully enclosed version with just a USB port exposed.

I’ve uploaded the model to Printables here:
https://www.printables.com/model/1427837-milwaukee-m18-battery-tester-holder

Happy to get your feedback or suggestions for improvement!

Thanks to all for sharing your research with the community !