diff --git a/docs/extras/installing_android.md b/docs/extras/installing_android.md
index 2528ddc0..091c278b 100644
--- a/docs/extras/installing_android.md
+++ b/docs/extras/installing_android.md
@@ -48,7 +48,7 @@ This page will also *not* detail things such as rooting and overclocking; extern
 
 ### Step 0: Preparation
 
-If you have official Joy-Con controllers, you can set up auto-pairing so undocking them seamlessly connects to the console regardless of what OS is running. To make this work, boot HOS, ensure both work undocked (pair them), then reboot to hekate. Select `Nyx Options` followed by `Dump Joy-Con BT`. You should see "Found 2 out of 2 Joy-Con pairing data!"
+If you have official Joy-Con controllers, you can set up auto-pairing so undocking them seamlessly connects to the console regardless of what OS is running. To make this work, boot HOS, ensure both work undocked (pair them), then reboot to hekate. Put the Joycons back on the rails, select `Nyx Options` followed by `Dump Joy-Con BT`. You should see "Found 2 out of 2 Joy-Con pairing data!"
 
 ::: tip
 
diff --git a/docs/user_guide/rcm/entering_rcm.md b/docs/user_guide/rcm/entering_rcm.md
index b043d0d9..9911d6c4 100644
--- a/docs/user_guide/rcm/entering_rcm.md
+++ b/docs/user_guide/rcm/entering_rcm.md
@@ -25,7 +25,7 @@ The order of methods on this page is in the order of ease. The easiest method to
 ## Instructions:
 
 1. Power off the Switch and short the pins on the right Joy-Con rail using one of the methods listed below.
-1. While holding the `Volume Up` button, press the `Power` button once while holding `Volume Up`.
+1. While holding the `Volume Up` button, press the `Power` button once.
     - If your Switch displays the Nintendo logo and boots normally (or the screen was on and goes black), you didn't successfully enter RCM and should try again. Otherwise, if your console still has a black screen (even after tapping the power button again), your Switch is in RCM and you can let go of the `Volume Up` button.
 1. Once your Switch is in RCM, remove the RCM jig (if applicable) and continue with the next page of the guide by clicking on the button at the bottom of this page.