Wrong reporting during closing

[englolo]

Hi,
I'm experiencing some strange reporting behavior when closing garage door.
Initially is reporting "closing" but after second or two is reporting "opening" until door is closed.
It's happening either ways, using original remote controller or controlling from HA.
This is quite important for the rest of automation.

Additional to first issue, on opening showing "position:100%" and then when door is fully open on idle "position:0%". In logs line 515-528.

Hardware is Nice Soon (before 2018 with rj11 connector), D1mini esp8266 and Waveshare SN65HVD230 CAN Board.

Including full log , first is opening and at line 537 is closing.
Logs:
logs_garage-door_logs.txt

[englolo]

Hi,
I think I found the problem.
The controller always returns data[11] as 0x02, STA_OPENING in Submenu Status in motion - sub_run_cmd2 -line 587.

case STA:
     ESP_LOGI(TAG,  "Подменю Статус в движении" );
     switch (data[11]) {    
         case STA_OPENING:
         case 0x83: // Road 400
             ESP_LOGI(TAG, "Движение: Открывается" );
             this->current_operation = COVER_OPERATION_OPENING;
             break;

Just need to find an elegant solution for all cases.

[francordi85]

Hi,

I have the same problem.
Have you solve it ?

logs_rb400_logs.txt

[englolo]

Hi,
I comment out the whole block switch (data[11]) with all cases, in nice-bust4.cpp - line 587 .
Now displays open, closed, opening and closing correctly.
Only in some situations it shows Position: 100% and then 0% and vice versa, but I haven't researched that yet.
In your case it also shows the strange values for Position:.