Multi ESP32 signals not fused

[Ying-Kai-Liao]

I prepared 3 ESP32-S3, connected to AP from raspberry pi, and host the aggregator (main server) on the pc. Can receive signals from different node ids but not triggering any kind of signal fusion and fail to detect people count/ pose at all. Barely can say the signal is changing while moving (vitals) but nothing about position / pose is working.

trim.DFF94B10-0DA2-428E-A846-799CA996297E.MOV

[JarrodLambert]

I'm having a similar issue!

[ak1ca1]

Same

[Leeeeeeedw]

I also setup 3 ESP32-S3, and config with "python firmware/esp32-csi-node/provision.py --port COM7 --ssid "YourWiFi" --password "YourPassword" --target-ip 192.168.1.20 --node-id 1" command, but when I use the aggregator to listen the data, it will receive data from 3 different IP but same node_id 1. Do you know why? Or how do you config the node-id?

[Velociraptor85]

How did you verify that the node id is the same ?
I used the aggregator bin and than the "RUST_LOG=debug " prefix is a great help also when you use the idf monitor it tells you which id the esp thinks he has so you could cross check if it was set correctly

[Leeeeeeedw]

I setup 3 ESP32-S3 and use the aggregator to listen the data, you can see there are 3 different IPs but all the "node: 1" from the below picture

BTW, how to use the "idf" and the "RUST_LOG=debug " prefix? Is this in the user-guide or other chapter?

[Velociraptor85]

the rust log prefix is mentioned in #334 (comment)

I could not find the reference to the esp monitoring command but it was essentially idf port monitor

But since you already flashed three different esps I would reflash it and provision again with the node id option.

[Leeeeeeedw]

Thanks!

I already reflash and provision with the "node-id" option today, but it didn't work finally, I don't know how to fix this problem...