The printer is DANGEROUS with current firmware with no option to upgrade!

[kiler129]

Beyond the version beyond severely outdated the current firmware has no thermal runaway enabled. It can cause fires - it’s beyond my understanding how Tenlog can just ignore that?

[Meicalnissyen]

Well, saves me going thru Tom's tests. thats bad, and not suprising.

They ship it with a stranded mains line rubbing on cut extrusion, Oveture includes a repair kit with each roll

[PeKaWe]

I tried at my TL-D3 Pro to disconnect thermal sensor. The printer tirns off immediately.

[kiler129]

I tried at my TL-D3 Pro to disconnect thermal sensor. The printer tirns off immediately.

Have you tried pulling it or disconnecting it completely? Because this is a different type of detection.

[PeKaWe]

I have simulated a broken wire. This seems to me to be the most likely issue.