Archim 1.0.a HW

[apan018]

problem flashing...

it will flash half way (COM port change from 3D Printer Powered by RAMbo -> Bossa Program Port ) and as soon as it switch again back to 3D printer by RAMbo this is when it failed

log:

[==============================] 100% (559/559 pages)
Verify successful
done in 4.471 seconds
Set boot flash true
readWord(addr=0x400e0a08)=0x1
readWord(addr=0x400e0c08)=0x1
writeWord(addr=0x400e0a04,value=0x5a00010b)
readWord(addr=0x400e0a08)=0
readWord(addr=0x400e0c08)=0x1
readWord(addr=0x400e0a08)=0x1
readWord(addr=0x400e0c08)=0x1
CPU reset.
readWord(addr=0)=0x20088000
readWord(addr=0xe000ed00)=0x412fc230
readWord(addr=0x400e0740)=0
readWord(addr=0x400e0940)=0x285e0a60
writeWord(addr=0x400e1a00,value=0xa500000d)
Couldn't find a Board on the selected port. Check that you have the correct port selected. If it is correct, try pressing the board's reset button after initiating the upload.