Z-AXIS MOTOR CURRENT

[danman454]

Hey All. I'm trying to upgrade my printer with the Einsy Rambo 1.1 and it's been quite the challenge for me. I'm fairly new with this stuff and still learning. The issue i'm having right now is my z axis. The motors seem to be under powered. Both motors spin together but barely holding the shaft stops them (motors pulled from printer). The board i had before was the Mks base 1.5 which gave the motors a ton of torque. It was easier to adjust on the mks board because the drivers had trimpots. The Einsy does not. Any help would be appreciated. i've added my confg.h and confg.adv.h Thanks!
Marlin.zip

[Elocai]

it´s even easier on the einsy because it does not (use any trimpots).

just go check your configuration advanced file, look for the tmc2130 setting, there is a value for current which you just have to type in, and a factor for holding current, and a mode select for spreadcycle for more reliability and...and....and.... : )