Is the probe wizard intended for metric use only? I used Imperial values at first,then went back to metric. Everything works great until I run code with a tool change in it. As soon as the second tool change hits, probe wizard errors "probe tripped during Z movement" and several other errors. Then the rest of Probe Wizard fails to work. All probe routines fail with an error. Restart Mach3 and Probe Wizard works perfect again. I shortened up some test code to just the initial tool change. That seemed to work fine. Additional tool changes cause all kinds of problems. Any help would be greatly appreciated.
Is the probe wizard intended for metric use only? I used Imperial values at first,then went back to metric. Everything works great until I run code with a tool change in it. As soon as the second tool change hits, probe wizard errors "probe tripped during Z movement" and several other errors. Then the rest of Probe Wizard fails to work. All probe routines fail with an error. Restart Mach3 and Probe Wizard works perfect again. I shortened up some test code to just the initial tool change. That seemed to work fine. Additional tool changes cause all kinds of problems. Any help would be greatly appreciated.