Add initial Arduino sketch to Arduino-Code-Incubator

Blink/Blink.ino

@@ -0,0 +1,37 @@
+/*
+  Blink
+
+  Turns an LED on for one second, then off for one second, repeatedly.
+
+  Most Arduinos have an on-board LED you can control. On the UNO, MEGA and ZERO
+  it is attached to digital pin 13, on MKR1000 on pin 6. LED_BUILTIN is set to
+  the correct LED pin independent of which board is used.
+  If you want to know what pin the on-board LED is connected to on your Arduino
+  model, check the Technical Specs of your board at:
+  https://www.arduino.cc/en/Main/Products
+
+  modified 8 May 2014
+  by Scott Fitzgerald
+  modified 2 Sep 2016
+  by Arturo Guadalupi
+  modified 8 Sep 2016
+  by Colby Newman
+
+  This example code is in the public domain.
+
+  https://www.arduino.cc/en/Tutorial/BuiltInExamples/Blink
+*/
+
+// the setup function runs once when you press reset or power the board
+void setup() {
+  // initialize digital pin LED_BUILTIN as an output.
+  pinMode(LED_BUILTIN, OUTPUT);
+}
+
+// the loop function runs over and over again forever
+void loop() {
+  digitalWrite(LED_BUILTIN, HIGH);  // turn the LED on (HIGH is the voltage level)
+  delay(1000);                      // wait for a second
+  digitalWrite(LED_BUILTIN, LOW);   // turn the LED off by making the voltage LOW
+  delay(1000);                      // wait for a second
+}

README.md

@@ -1 +1,16 @@
-# Arduino-Code-Incubator
+# Arduino-Code-Incubator
+
+A collection of Arduino sketches and code examples.
+
+## Sketches
+
+| Sketch | Description |
+|--------|-------------|
+| [Blink](./Blink/Blink.ino) | Blink the built-in LED on and off every second |
+
+## How to Use
+
+1. Open the Arduino IDE.
+2. Navigate to the sketch you want to use.
+3. Open the `.ino` file.
+4. Connect your Arduino board and upload the sketch.