SKR Mini E3 V2 Ender 3 Series Pre-Compiled Firmware

Stock Bl Touch/CR Touch Mount

Bowden Setup

SKR Mini E3 V3 Ender 3 Series Pre-Compiled Firmware

Enabled ZProbe Wizard
Adjusted probing margin suitable for Hero Me Gen Mount.

Pre - Compiled only for Ender 3 Series with Bl Touch.

SKR Mini E3 V3 Ender 3 Series Pre-Compiled Firmware

[We don't hold any responsibility with firmware, please perform test homing heating and cooling and extruding test before conducting test print.]

Based on Marlin 2.0.9.3

DREMC (Support ONLY BL Touch via dedicated header) (Stock Bowden Configuration) For Ender 3

Tested in Ender 3 Pro and Ender 3 V2 Stock with Bl Touch using Official Creality Bracket. If you using custom mount, use gcode to adjust z-off set. This firmware is provided as is, if you encounter any issues please submit a issue. See attached .zip for source or check our github tree for latest changes.

Please rename to firmware.bin to flash firmware.

• Increased Max Acceleration
• Enabled Classic Jerk (Suitable for Linear Advance)
• Official Creality Bl Touch Mount Off-Set [{ -40, -16, 0 }] - Please adjust your babystep, this will depend on your hotend
• BL Touch via Dedicate header NOT using Z-endstop method. (Full Source available if you wish to change/alter configuration)
• Increased Homing Speed
• Replaced ABS Pre-Heat to PETG Settings
• Advance Paused Enabled
• Hotend Fan turn off when hotend is not active

CR10 Mini DD

Direct Drive (default e-step configured for micro swiss direct drive)
No BL Touch

Added PID BED

FOR CR10 mini ONLY

Note: Micro Swiss Hotend Auto tuned, we recommenced to run auto tune again at 200 degree for other hotend.

Ender 5 Pro

SKR E3 V2.0 Board
Micro Swiss Direct Drive
BL Touch [Via header]
Bigtreetech Smart Filament Sensor

Contributors
ANZAC