Assembly Guide

Camera Assembly

Follow these steps to assemble the camera:

1. Print the Necessary Parts

• Start by printing all required parts.

2. Insert Threaded Inserts

• Place all M3 threaded inserts in their respective slots.

3. Glue the Camera Support

• Use CA glue or 3D-printing-specific bonding glue to attach the camera support to the right_case part as shown on the previous image.

4. Install the Camera Module

• Secure the camera module using M3x4mm screws.

5. Fit the Camera Ribbon

• Thread the camera ribbon through the designated slot.

6. Prepare the Raspberry Pi

• Insert the SD card into the Raspberry Pi.
• Attach the Raspberry Pi to the touchscreen.
• Connect the camera ribbon cable to the Raspberry Pi.
• Slide the Raspberry Pi and screen assembly into the case.

7. The shutter button

• Put the push button in the dedicated part and close it using CA glue or similar. Be careful not to glue the moving parts !

8. Assemble the Main Unit

• Using the almighty hot glue, secure the USB C connection as shown below.

• Slide in the battery pack in its location and add the charging/step up board in the front of the pack.
• Connect the PCB button board, the shutter button and the battery to the GPIO using the following diagram.

9. Close it

• Using the two link parts, secure the battery pack
• Slide both parts of the cases together and using the 4 M3 screws left, close the assembly.
• This is what it 'should' look like :