An open-source automatic bed-levelling program, that can be used with cheap and commonly-available hardware to level any printer (only tested on MARLIN firmware)
- Arduino Uno (Or any other arduino - just make sure to change the 'chipselect' variable to suit the type of board)
- Sharp GP2Y0A51SK0F Analog Distance Sensor (Can be found here - Not affiliate)
- 3-Pin JST Cable (Can be found here - Not affiliate)
- SD Card Shield (Can be found here - Not affiliate)
- 3D Printed parts (Can be found here)
- Aaaaaand a 3D printer :)